Owner's Manual
Table Of Contents
- User Manual
- Table of Contents
- Important Safety Instructions
- Introduction
- Key Features and Applications
- Package Contents
- Rack Installation Guide
- Hardware Overview
- Connections
- Network Connection Overview
- Software Overview
- Sources
- Zones (Zone Outputs)
- Zones-Limiter
- Zones-Groups Overview
- Room Combine Active
- Message Player Overview
- Messages
- GPIO Overview
- Scenes Overview
- Routines Overview
- Accessories Overview
- Accessories Page
- Print, Assemble, Place, and Scan
- X-ANS General Settings
- Accessories Connection Rules
- Scheduler, Steps to Create an Event
- Diagrams – Connection Diagram and Block Diagram
- Settings Page Overview
- Front Panel Display Menu Tree
- Specifications
- Mechanical Line Drawings with Dimensions
- Regulatory Information: AZM4 / AZM8 / A-BT
- Limited Warranty, Customer Service Online Warranty Claim Process
- Quick Start Guide
- Product Info
- System Examples
Atmosphere
User Manual
AtlasIED.com
TELEPHONE: (800) 876-3333
SUPPORT@ATLASIED.COM
1601 JACK MCKAY BLVD.
ENNIS, TEXAS 75119 U.S.A.
– 46 –
Routines Overview
The AZM now has numerous capabilities called ‘Actions’. An Action is either a Scene, Message, GPO Preset, Bell Schedule Recall, or Room Combine. Routines
allow you to set up and save up to 20 groups of Actions and recall or “run” them as a single Action. A Routine can be triggered in the following ways:
• By selecting as a GPIO Trigger Routine. (See GPIO Tab for example of using a contact closure button)
• By selecting it as a Scheduled Event in the scheduler.
• By setting it up in the Actions tab in a C-ZSV controller.
• By setting it up in the Actions tab in a virtual wall controller.
Setting up a Routine
1. In the UI, select the Routines tab.
2. Select ADD ROUTINE, name the routine in the pop-up screen, and select OK.
3. RUN ROUTINE= audition an existing routine, make some changes and rename/save. Note: Exiting page saves settings.
4. Enable the actions to be included in the routine.
5. Select to apply the combine action for any included groups if desired. In this example group-1 will be uncombined, and group-2 will be ignored.
6. Select scene to include in the routine.
7. Select “>” navigates to the specific set up pages for each action.
8. The total set-up routines out of a max of 20.