Owner's Manual
Table Of Contents
- User Manual
- Table of Contents
- Important Safety Instructions
- Introduction
- Key Features and Applications
- Package Contents
- Rack Installation Guide
- Hardware Overview
- Connections
- Network Connection Overview
- Software Overview
- Sources
- Zones (Zone Outputs)
- Zones-Limiter
- Zones-Groups Overview
- Room Combine Active
- Message Player Overview
- Messages
- GPIO Overview
- Scenes Overview
- Routines Overview
- Accessories Overview
- Accessories Page
- Print, Assemble, Place, and Scan
- X-ANS General Settings
- Accessories Connection Rules
- Scheduler, Steps to Create an Event
- Diagrams – Connection Diagram and Block Diagram
- Settings Page Overview
- Front Panel Display Menu Tree
- Specifications
- Mechanical Line Drawings with Dimensions
- Regulatory Information: AZM4 / AZM8 / A-BT
- Limited Warranty, Customer Service Online Warranty Claim Process
- Quick Start Guide
- Product Info
- System Examples
Atmosphere
User Manual
AtlasIED.com
TELEPHONE: (800) 876-3333
SUPPORT@ATLASIED.COM
1601 JACK MCKAY BLVD.
ENNIS, TEXAS 75119 U.S.A.
– 53 –
Setting up Accessory Port wall controllers
Note: see Inputs - Audio Wall Plates section for A-XLR, A-RCA, and A-BT settings UI pages
General Settings Page for C-ZSV
1. The General Settings page shows the connected port, with settings pages for Zone Audio Control, Messages, Actions, Screen Settings,
and Light Ring.
2. Accessory name – displays the editable name for this accessory.
3. Connected port ID, and location of the accessory on the port wiring bus (Port A-position 2).
4. Import settings – allows a saved configuration file to be imported to duplicate an existing setup.
5. Export settings – saves the configuration file as a backup or to use for importing.
6. Reset settings – allows selecting between: reset to default values or reset parameters and reboot accessory.
7. The locate icon can be clicked on or off causing the connected device to flash to physically identify its location. If left on, it will automatically shut
off after 30 minutes. Additionally, pressing or turning the encoder on the controller will cancel the locate flashing.
8. In addition to the wired wall controller a virtual wall controller is automatically created that emulates the settings by scanning the QR code. There
are various ways to use the QR codes: Copy Link, Open in New Window, or Print the QR code for display in the GEM mounting frame.
Image 5