Owner's Manual

©2020 Atlas Sound LP. The Atlas “Circle A”, Soundolier, and Atlas Sound are trademarks of Atlas Sound L.P. IED is a Registered Trademark of Innovative Electronic Designs LLC. All rights reserved. All other Trademarks are property of their respective owners. No endorsement is implied. Due to continual product development, specifications are subject to change without notice. ATS001449 RevE 6/20
AtlasIED.com
TELEPHONE: [phone]
[e-mail]
1601 JACK MCKAY BLVD.
ENNIS, TEXAS 75119 U.S.A.
Step 1
Remove the M1000 from the package via hangers provided. Hangers are factory installed to facilitate mounting of the M1000 for upward sound
dispersion, Figure 1. This dispersion configuration is the most popular and most effective.
Note: The M1000R-W can only be mounted in the upward firing configuration.
If horizontal (side firing) dispersion is required, the hangers may be relocated as shown in Figure 2. If down firing dispersion is required, the hangers
may be relocated as shown in Figure 3.
Step 2
Install the M1000 per Figure 1, 2 or 3, using hanger wire or MCHAIN72 (not included). Uniform speaker spacing is critical, typically 12' to 15' apart.
Note: Code requirements in many areas require the use of #12 suspension cable for commercial applications. Check your local codes before installing
the M1000.
Step 3
Terminate service loop to the amplifier output line (black is negative, red is positive) - see Figure 4.
Note: Strain relief is not designed to accommodate conduit. Use approved terminations through the knock-outs provided on the M1000 cover plate
when conduit is used.
Step 4
Set tap selector switch to desired power setting.
Install Sheet
M1000 / M1000-W / M-1000R-W
WARNING: To prevent injury, this apparatus must be securely attached to the floor / wall / ceiling in accordance with installation instructions.
Figure 1
M1000 shown with hangers
located as configured from
factory for upward sound
dispersion
Figure 3
M1000 shown with hangers
configured for downward sound
dispersion
Figure 2
M1000 shown with hangers
configured for horizontal sound
dispersion
Figure 4
M1000 tap selector
Model Loudspeaker
Magnet
Weight
Sensitivity
Frequency
Response
Transformer
Taps
Enclosure
Weight
Dimensions Volume
M1000
8" (203mm)
Dual Cone
10oz
(283g)
97dB Peak,
94dB Average
100Hz - 10kHz
.25, .5, 1, 2
and 4W
11.57" x 11.57" x 5.5"
(294mm x 294mm x 140mm)
734 in
3
9lbs
(4.1kg)
M1000-W
8" (203mm)
Dual Cone
10oz
(283g)
97dB Peak,
94dB Average
100Hz - 10kHz
.25, .5, 1, 2,
4W and 8Ω
11.57" x 11.57" x 5.5"
(294mm x 294mm x 140mm)
734 in
3
9lbs
(4.1kg)
M1000R-W
8" (203mm)
Dual Cone
10oz
(283g)
97dB Peak,
94dB Average
100Hz - 10kHz
.25, .5, 1, 2
and 4W
12.99" dia. x 3.94"
(330mm dia. x 100mm)
382 in
3
9lbs
(4.1kg)