Industrial PT-1000 Temperature Probe Reads Probe type Range Accuracy Reaction Time Cable length Connector Output Life expectancy Temperature Class A platinum, RTD -55˚C to 220 ˚C +/- (0.15 + (0.002*t)) 90% in 13s 3 Meters Tinned leads Resistance (Analog) 15 years V 1.
Measurements Cable Length 3m (10’) Ø 4.8mm 26mm (1”) 25mm (0.9”) 3/4 NPT 74.5mm (2.9”) 30mm (1.1”) 6.4mm (.25”) 2 Copyright © Atlas Scientific LLC Ø 4.
Red R1+ Red Red R1+R Wiring guide This four wire PT-1000 probe can be connected to any device that can read a two, three or four wire PT-1000 temperature probe. Green Green Green R2+ R2+R A PT-1000 temperature probe converts the resistance of platinum to temperature.
Specifications Cable length Weight Max cable temp Sensing material Threading Tinned leads Sterilization Food safe 3m (10 feet) 140 grams 125°C Platinum (3/4") NPT Yes Chemical / Autoclave Yes Materials Black Ryton EPDM 304 stainless steel PVC Polyethylene PVC This PT-1000 probe can be fully submerged in fresh or salt water, up to the Tinned leads indefinitely.
NSF/ANSI 51 Compliant Atlas Scientific LLC, hereby certifies that, Industrial PT-100 Temperature Probe Part # ENV-50-TMP Complies with NSF/ANSI Standard 51 EPDM PVC Polyethylene Black Ryton PVC NSF-51 Compliant EPDM NSF-51 Compliant Black Ryton NSF-51 Compliant Polyethylene NSF-51 Compliant 304 stainless steel NSF-51 Compliant 5 Copyright © Atlas Scientific LLC 304 stainless steel
Operating principle Unlike any other material, platinums correlation between resistance and temperature seems to be woven into the fabric of the universe. It is for this reason, that the platinum RTD temperature sensor is the industrial standard for temperature measurement. Resistance 78 Nickel Pt Platinum 195.
The PT-1000 temperature probe is a resistance type thermometer. Where PT stands for platinum and 1000 is the measured resistance of the probe at 0˚C in ohms (1k at 0˚C). As the temperature changes the resistance of the platinum changes.
How to connect the Industrial PT-1000 Temperature probe Non-Isolated TX RX N/C VCC GND The Atlas Scientific ™ Industrial PT-1000 temperature probe can be connected in several different ways. The following show two examples: PULL UP VCC PRB PGND 1 2 Using the terminal block option on our non-isolated EZO™ Carrier Board, you can easily connect the Industrial PT-1000 Temperature probe to our EZO™ RTD Circuit.
Probe cleaning Over time PT-1000 probes can become dirty and covered in deposits. Both soft and hard coatings can be removed by lightly brushing around the sensing area.
