Warranty Manual

AT-GAIN-120
21
Basic Operation
1. Click the ENABLE option, if it is not selected.
2. Set the time interval, which must elapse, before the AT-GAIN-120 powers-down. The default setting is 15
minutes.
3. Click the Save button.
Enabling this mode will place the AT-GAIN-120 into a very-low power mode where power consumption is limited to
0.5 W. When in hibernation mode, there will be no audio output or network communication. The PWR LED indicator
will blink once every second to indicate that the AT-GAIN-120 is in hibernation mode. By default this feature is
disabled.
To wake the AT-GAIN-120 from hibernation mode, use one of the following methods:
• Press and hold the IP RESET button on the rear panel for approximately 3 seconds, but no longer that 5 sec-
onds, using the end of a paper clip or other pointed object.
• Pull the trigger high using a control system such as Atlona Velocity. Note that even if the Unit Trigger option is
set to DISABLE, this method will still wake the AT-GAIN-120.
Hibernation mode
1. Click the ENABLE option, if it is not selected. The following dialog will be displayed:
To cancel, before entering hibernation mode, click the CANCEL button. Otherwise, once the dialog time expires,
the AT-GAIN-120 will be placed in hibernation mode. To wake the AT-GAIN-120, use one of the methods listed
above.
WARNING: If exiting hibernation mode, do not hold the IP RESET button for longer than 5 seconds.
If this occurs, then the AT-GAIN-120 will switch IP modes.