Warranty Manual

AT-GAIN-120
24
Basic Operation
Network Audio
The AT-GAIN-120 supports Dante and AES67 audio streams with the addition of the optional AT-GAIN-NET audio
card, which can be purchased from Atlona. Refer to Network Audio Card Installation (page 40) for information on
card installation.
For setup and control of Dante / AES67 audio routing and conguration, refer to the Audinate Dante Controller
software. AMS 2.0 and the web graphical interface of the AT-GAIN-120 supports basic network, control, and audio
level adjustments.
1. Download the Audinate Dante Controller software from the following URL:
https://www.audinate.com/products/software/dante-controller
2. Make sure that an Ethernet cable is connected from the INPUT port on the rear panel to the network.
3. Launch the Dante Controller software.
The AT-GAIN-NET network audio card will appear as NetAudio-xxxxx, where xxxxx refers to the last ve
hexadecimal digits of the network card MAC address.
Dante Software Conguration
IMPORTANT: The AT-GAIN-120 must be connected within the same network segment as the Dante
Controller, in order to utilize mDNS.
NOTE: The AT-GAIN-120 was tested using Audinate Dante Controller software v4.0.6.5 and Java
v1.8.0. Atlona recommends using Audinate Dante Controller software v4.0.6.5 or higher.
AT-GAIN-NET card