Warranty Manual

AT-GAIN-120
35
The Web GUI
Audio page
Input Selection
Click this drop-down list to select the audio input: Analog or Net Audio. The Net Audio selection will only be
available if the optional AT-GAIN-NET card is installed. This card is available from Atlona.
Output Status
Displays the current output impedance setting.
Equalization (Graphic, 5-band)
Click and drag each of these sliders to adjust the output frequency range. Each band has a range from -10 dB to
+10 dB. The following table provides a general breakdown of each frequency in the audio spectrum.
Auto Reset
Click this button to reset all equalizer bands to their default settings. Refer to Default Settings (page 43) for more
information.
Mute
Click this button to mute the audio output. Note that clicking this button will mute all audio output ports: LINE OUT,
4 / 8 Ω OUT, and 70V / 100V OUT.
Volume
Click and drag this slider to adjust the output volume. This volume slider only aects the output volume on the
speaker outputs. It does not aect the audio volume of the LINE OUT port, as this port is a xed-level port. Note
that the volume range for this slider is not measured in decibels.
Slider Description General Range
40 Hz Sub-bass frequency 20 Hz - 50 Hz
150 Hz Bass frequency 50 Hz - 200 Hz
500 Hz Upper-bass to lower midrange 200 Hz - 800 Hz
2 kHz Midrange to upper midrange 800 - 4 kHz
10 kHz “Brilliance” frequency 7 kHz - 12 kHz