Warranty Manual

AT-GAIN-120
40
Appendix
Network Audio Card Installation
1. Disconnect the power cord from AT-GAIN-120.
2. Set the AT-GAIN-120 on a at surface, free of obstructions. Position the AT-GAIN-120 as shown in the picture
below.
3. Using a small Phillips-head screwdriver, remove the two screws holding the faceplate in place. After the
faceplate is removed, set it aside. Keep the two screws to attach the included faceplate with the INPUT card.
WARNING: To prevent the risk of electrocution or electric shock, always disconnect the power cord
from the AT-GAIN-120 before installing or removing the AT-GAIN-NET network card.
Phillips-head screws
The AT-GAIN-NET is an optional audio card which allows Dante and AES67 audio streams to be used with the AT-
GAIN-120. Follow the instructions below to install the AT-GAIN-NET audio card.