Installation Guide

10
Installation Guide
AT-GAIN-60
Mounting two AT-GAIN-60 units
1. Turn the AT-GAIN-60 so that the bottom of the unit is facing upward.
2. Locate the two sets of holes on either side of the unit. Refer to page 7 for the location of
the mounting holes.
3. Mount each of the AT-GAIN-60 units in the rack. Match the mounting holes on the bottom
of each AT-GAIN-60 with the holes marked in the illustration below.
The following provides an alternate method for mounting AT-GAIN-60 units closer together.
This option provides extra space in the AT-RACK-1U (not included) for cabling, etc.
4. Install the rack tray in the rack shelf and secure the rack tray with two screws on either side.
Front of rack tray
TOP