Installation Guide
5
Installation Guide
AT-GAIN-60
IP Conguration
By default, the AT-GAIN-60 is set to DHCP mode, allowing a DHCP server (if present) to assign
the unit an IP address.
Press and hold the INPUT button for approximately 10 seconds. Release the button once both
input LED indicators 1 and 2 begin to ash. The number of ashes will indicate the currently
selected IP mode:
LED ashes Description
Two Static mode IP address: 192.168.1.254
Subnet mask: 255.255.0.0
Gateway: 192.168.1.1
Four DHCP mode
Switching the IP mode
DC28VAUDIO IN 2
INPUT GAIN
L R
L
TX RX
R
3.4A
-22
-2
-4
-20
-19
-14
-9
CLASS 2 WIRING
24 / 70 / 100V OUT
CLASS 2 WIRING
dB
INPUT LED indicators
INPUT button
Resetting to Factory-Default Settings
Press and hold the RESET button, on the back of the unit, for approximately 10 seconds, then
release. The LED indicators on the LAN port will ash and the unit will automatically reboot.
Note that the AT-GAIN-60 will be placed in DHCP mode, as part of the reset procedure.