Warranty Manual

AT-GAIN-60

Use the IPStatic and IPDHCP commands to switch between DHCP and static IP mode using Telnet or RS-232.

Refer to the Application Programmers Interface documentation for more information. All commands and their

arguments are case-sensitive.

Using Commands

• Setting static IP mode

1. Connect to the AT-GAIN-60 using Telnet.

2. At the command line, execute the IPDHCP command using the o argument, as shown.

IPDHCP o

3. Execute the IPStatic command. This command requires three arguments: the desired IP address of the

AT-GAIN-60, the subnet mask, and the gateway address. All arguments must be entered in dot-decimal

notation. The following is an example:

IPStatic 192.168.1.112 255.255.255.0 192.168.1.1

4. The AT-GAIN-60 will automatically reboot. The unit is now set to static IP mode and ready for use.

Installation

• Setting DHCP mode

1. Connect to the AT-GAIN-60 using Telnet.

2. At the command line, execute the IPDHCP command using the on argument, as shown. All characters are

case-sensitive.

IPDHCP on

3. The AT-GAIN-60 will automatically reboot. The unit is now set to DHCP mode and will be assigned an IP

address by the DHCP server (if present).