Warranty Manual

AT-GAIN-60

Basic Operation

1. Click the ENABLE option, if it is not selected.

2. Set the time interval, which must elapse, before the AT-GAIN-60 powers-down. The default setting is 15 minutes.

1. Click the ON option, if not already selected, to enable Auto Power On mode.

2. Click OFF to disable this feature.

Enabling this mode will automatically power-down the AT-GAIN-60 if no audio input signal is present on either the

AUDIO IN 1 port or the AUDIO IN 2 port, after the specied time interval. When the AT-GAIN-60 enters Auto Power

Down mode, the Power option will be set to OFF and the front-panel LED indicators will turn o. In Auto Power

Down mode, power consumption is limited to 1.2 W. By default this feature is enabled.

Note that when this mode is enabled, the AT-GAIN-60 only monitors the existence of an audio input signal, not the

physical audio connection. Refer to the next page for instructions.

When enabled, Auto Power On mode will automatically power-on the AT-GAIN-60 when an input signal is detected

on either the AUDIO IN 1 or AUDIO IN 2 port. When the AT-GAIN-60 is powered-on from a low-power state, the

PWR, INPUT, and VOL LED indicators will be illuminated. By default this feature is enabled.

Auto Power Down mode

Auto Power On mode

IMPORTANT: When Auto Power On is set to ON and an audio signal is present, the AT-GAIN-60

cannot be powered-o in the web GUI or through a Telnet session. To control powering of the AT-

GAIN-60, regardless of whether or not an input signal is present, the Auto Power O feature must be

set to OFF.