User manual

atlona.com

Toll free: 1-877-536-3976

Local: 1-408-962-0515

TCP/IP

Warning!: Do not connect the matrix Ethernet port until the first steps have been followed.

BEFORE YOU PLUG IN ANYTHING: Verify no other devices on the network have the IP of

192.168.1.10 (the matrix default is 192.168.1.10).

There are two ways to set TCP/IP control when any of the products on the network have the same

IP address as the matrix: RS-232 or through Ethernet on a non networked computer.

RS-232 TCP/IP Set up (Preferred)

Ethernet TCP/IP Set up (If RS-232 is not available)

Step 1: Follow RS-232 set up instructions on page 15

Step 2: Open Hyperterminal program

Step 3: Verify DHCP is off

Send command “IPDHCPsta” followed by a carriage return

Feedback should be “DHCPoff”

If DHCP is on use command “IPDHCPoff” to turn DHCP off

Step 4: Change the current IP using the command “IPStatic 192.168.0.200 255.255.255.0”

IP can be anything that system devices aren’t currently using. (200 is just an example)

Step 5: (optional) Change the port using the command “IPPort 4400” followed by a carriage return

4400 is just an example. The port can be changed to what is needed/wanted

The matrix is now ready to be used for TCP/IP control. The Ethernet cable may be connected now.

Step 1: Connect Ethernet to a computer

Step 2: Right click the network icon at the bottom right side of screen and

open network and sharing center on PC (see picture A)

Step 3: Select internet type connection/local area connection (see picture B)

Step 4: Select properties (see picture C)

Step 4: Select IP V.4 and press properties (see picture D)

C D

Note: If IPLogin is turned on, default TCP/IP log in is ~ username- root password- Atlona