Two-Input Wall Plate Switcher for HDMI and VGA Inputs with HDBaseT Output AT-HDVS-150-TX-WP User Manual Please check http://www.atlona. com/AT-HDVS-150-TX-WP for the most recent firmware update or manual. atlona.
Table of Contents 1. Introduction ................................................................................... 3 2. Package Contents ................................................................................... 3 3. Features ................................................................................... 3 4. Compatibility ................................................................................... 3 5. Auto switching ...................................................
Introduction The Atlona AT-HDVS-150-TX-WP is a 2×1 wall plate switcher with display control for HDMI and VGA transmission over HDBaseT™. It features an HDMI input plus VGA input with 3.5mm audio connector and a two-gang, US or UK two-gang wall plate. Plates without buttons are also available (AT-HDVS-TX-WP-NB).
Panel Description 1 2 3 LINK DISPLAY ON/OFF HDMI IN INPUT SELECT VGA IN AUDIO IN AT-HDVS-150-TX-WP 4 6 6 7 1. DISPLAY ON/OFF button: Sends RS-232 trigger command when used with a compatible receiver (ex. AT-UHD-CLSO-824 - see CLSO manual for instructions) Note: If DISPLAY ON/OFF button is held for 5 seconds it will switch the baud rate between 115200 or 9600 2. LINK LED: Illuminates when receiving power/signal from compatible receivers (ex. AT-UHD-CLSO-824) 3.
Wall Plate Installation The HDVS-150-TX-WP will fit in any 2 Gang (US & UK) electrical box or mud ring (that is at least 40mm deep). P -TX-W VS-150 AT-HD US When installing the US version, use the four shorter screws. Thread the screws through the face plate into the back box (as shown above). Note: Be sure to plug the CAT cable into the back of the wall plate before full installation P -TX-W VS-150 AT-HD UK The UK wall plate screws will be the longer than the US screws.
Set Up RS-232 control is available when used with appropriate power supply and HDBaseT receiver (ATUHD-CLSO-824) with RS-232 capabilities.
Specifications Video Resolutions Video 4096x2160@24/25/30/50*/60Hz*, 3840x2160@24/25/30/50*/60Hz* (UHD), 2048x1080p, 1080p@23.98/24/25/29.97/30/50/59.94/60Hz, 1080i@50/59.94/60Hz, 720p@50/59.
Safety Information Safeguards To reduce the risk of electric shock, do not expose this product to rain or moisture Do not modify the wall plug. Doing so will void the warranty and safety features. If the wall plug does not fit into your local power socket, hire an electrician to replace your obsolete socket. This equipment should be installed near the socket outlet and the device should be easily accessible in the case it requires disconnection.
Atlona, Inc. (“Atlona”) Limited Product Warranty Policy Coverage Atlona warrants its products will substantially perform to their published specifications and will be free from defects in materials and workmanship under normal use, conditions and service.
Disclaimers This Limited Product Warranty does not imply that the electronic components contained within Atlona’s products will not become obsolete nor does it imply Atlona products or their electronic components will remain compatible with any other current product, technology or any future products or technologies in which Atlona’s products may be used in conjunction with.
