User Manual
Table Of Contents
- Introduction
- Features
- Package Contents
- Panel Description
- Installation
- Configuration
- Basic Operation
- IR Control
- Advanced Operation
- The AMS Interface
- Appendix
AT-OMNI-121 / AT-OMNI-122
101
Advanced Operation
During use, the decoder can be switched to another multicast stream. However, if the decoder encounters a
missing stream, during the switch and when redundancy is enabled, then this will cause the decoder to automatically
failover to the multicast source congured as the backup. To prevent the decoder from automatically making the
redundancy switch, when redundancy is enabled, a grace period can be entered. By default, the grace period is set
to 0 seconds. If set to 0 seconds, automatic failover will occur if the stream is interrupted, for any reason. Refer to
Conguring Redundant Streams (page 54) for more information on enabling or disabling redundancy.
3. Locate the Change grace period eld.
4. Enter the desired value, in seconds. By default, this value is set to 0.
5. Click the Save button, at the bottom of the Output section.
1. Login to AMS. Refer to Accessing Decoders in AMS (page 19) if necessary.
2. Click HDMI OUTPUT in the menu bar.
Redundancy Grace Period