User Manual
Table Of Contents
- Introduction
- Features
- Package Contents
- Panel Description
- Installation
- Configuration
- Basic Operation
- IR Control
- Advanced Operation
- The AMS Interface
- Appendix
AT-OMNI-121 / AT-OMNI-122
114
The following Bidirectional section must be completed if two-way communication, between the encoder and
decoder is required. Bidirectional control is only supported for unicast control sources (not multicast).
Interface
Click this drop-down list to select the physical interface: eth1 or eth2.
Destination IP address
Enter the IPv4 address of the encoder in this eld.
Destination UDP port
Enter the destination UDP listening port in this eld.
Enable
Click this toggle switch to enable bidirectional serial communication. When enabled, the toggle switch will be green.
The AMS Interface
Interface Description
eth1 ETHERNET 1 port
eth2 ETHERNET 2 port
Interface Description
cli Displays the command-line interface of the decoder.
Output Serial port will send commands directly to the display device.
tcpproxy Commands are sent over IP but triggered over the serial port.
NOTE: The Bidirectional block will only be displayed if Mode is set to Output.
Name
The name used by AMS to identify the serial port.
Port
Click this drop-down list to select the port: serial_port1, serial_port2, or Not Used.
Mode
Click this drop-down list to select the desired control mode.
Serial Conguration