User Manual

AT-OMNI-121 / AT-OMNI-122
124
The AMS Interface
When these icons are clicked, the associated icons will be displayed in the rows and columns of the Virtual Matrix.
• Click the Video, Audio, and Data icons to return to the normal view.
• Since only HDMI (both audio and video) is being used, the V (video) and A (audio) icons are displayed. The blue
circle with the checkmark indicates that the cross-section has been created. However, not all streams are being
used. Refer to the chart below.
• This illustration also shows that the data stream (the icon with two arrows and three dots), which is used for
control, is also being used and is displayed as a dark-blue circle with the letter “D”.
• The icons in the upper-left corner can also act as a lter. This allows for a clear breakdown of where signals are
being routed and is useful when several encoders and decoders are used on a network.
Symbol Description
Video only
Audio only
Data only
Connected; not all signals are active
Connected; all streams are being used
V
A
D
IMPORTANT: R-Type and Pro compatiblity: R-Type encoders (AT-OMNI-512) and decoders (AT-
OMNI-521) operate in Video Mode, only. Pro encoders can be set to either Video Mode or PC
Mode. Video Mode is incompatible with PC Mode. Therefore, in order for both R-Type and Pro
encoders/decoders to work within a system, Pro encoders/decoders must be set to Video Mode.
Refer to Setting the Video Mode (page 30) for more information.
Audio stream
Data stream
Video stream