User Manual
Table Of Contents
- Introduction
- Features
- Package Contents
- Panel Description
- Installation
- Configuration
- Basic Operation
- IR Control
- Advanced Operation
- The AMS Interface
- Appendix
AT-OMNI-121 / AT-OMNI-122
30
Basic Operation
OmniStream oers two video modes: Video and PC application. These two modes will optimize the image, based
on the type of information that is being displayed. Use the Video mode when display motion graphics/video. Set
this mode to PC application when viewing static images, such as spreadsheets or similar content.
Setting the Video Mode
NOTE: In order to use 3840x2160p60 signals, the System mode must be set to Video.
1. Login to AMS. Refer to Accessing Decoders in AMS (page 19), if necessary.
2. Click the HDMI OUTPUT in the menu bar.
3. Scroll down to the Video Optimization section and click the Video Optimization drop-down list to select the
desired mode.
4. Click the SAVE button, within the Video Optimization section to commit changes. Note that switching between
video modes may take a few moments to complete.
5. Go to the encoder interface and repeat the process. Refer to the OmniStream Single-Channel / Dual Channel
A/V Encoder User Manual, if necessary.
Mode Description
Computer Graphics Optimizes the image when viewing static images, such as
spreadsheets or similar content.
Motion Video Provides the best viewing experience when streaming motion graphics
and/or video.