Installation Guide

Installation Guide
4
AT-RON-448
The AT-RON-448 provides two rack ears, which can be used to mount the unit in a standard rack
unit.
Mounting Instructions
The AT-RON-448 provides two EDID modes: internal (INT) and LEARN. Internal mode selects
the highest common resolution and audio between the source and all displays.
LEARN mode will copy the EDID information of the display/sink connected to the HDMI OUT 1
port.
To learn and EDID from the connected sink, press and hold the EDID button. While the EDID is
being learned, the LEARN LED will blink. EDID learn is complete when the LEARN LED glows
solid blue.
EDID
NOTE: 4K, 3D, and multichannel audio may not be available when using INT
(internal) EDID mode. When using this mode, the AT-RON-448 will build an
EDID, based on the capabilities of each display that is connected.
1. Remove the front two case screws from the sides of the case.
Rack installation
EDID
INT LEARN
1
2
3
4
5
6
7
8
SYNC
POWER
BM
AT-RON-448 EDID
INT LEARN
1
2
3
4
5
6
7
8
SYNC
POWER
BM