Owner's Manual

AT-WAVE-101
18
Control
Unit
Display
The WAVE-101 can send On/O commands to the display using an USB to RS-232 adapter (not included). This can
be set to a schedule through the webGUI Display control section or websocket (using the API found at https://atlona.
com/pdf/AT-WAVE-101_API.pdf).
The WAVE-101 can send On/O commands to the display using the display’s IP address. This can be set to a
schedule through the webGUI Display control section or websocket (using the API found at https://atlona.com/pdf/
AT-WAVE-101_API.pdf).
WAVE-101 has the ability to be controlled and to schedule on/o commands for the display.
WAVE-101 can be controlled using the built in webGUI or websocket.
The unit can be controlled using websocket. The commands can be found within the API at https://atlona.com/pdf/
AT-WAVE-101_API.pdf.
The unit has a built in web UI that will allow for unit conguration. See the WebGUI section, Settings, for more
information.
Websocket
WebGUI
RS-232
IP
TCP Proxy
This unit has the ability to translate IP data to RS-232 through ports 9001. This enables control of devices through
TCP/IP that only have RS-232 ports. The unit will take the commands sent to port 9001 and send them to the
corresponding port. A USB to RS-232 adapter (not included) will be required to use TCP Proxy.