Owner's Manual

AT-WAVE-101
22
webGUI
Instructor Page
By default, Auto Queuing Mode will be disabled.
Auto Queuing Mode Enable - Select the slider to enable and
disable the auto queuing mode on the instructor’s page. When
enabled, new content will be added to the queue on the side
of the instructor page, instead of directly to the HDMI display.
Maintenance Mode
By default, Maintenance Mode will be set to 3:30am.
Maintenance mode will go through and clear out all erroneous
data and left over media in the queue, then reboot the system.
Time - Select the time eld to set the time maintenance mode
will start. A pop up will appear with an easy to use clock for
selecting the time.
BYOD
AirPlay and Miracast PIN slider - Select to enable AirPlay and
Miracast PIN support. The pin will appear on the top right
of the Welcome Screen when an AirPlay or Miracast (P2P or
Infrastructure) source is detected.
Airplay URL Casting - Select to enable or disable Airplay URL
Casting.
Protocols
Airplay, Chromecast, Miracast - Select each individual slider to enable (orange) or disable (grey) each casting
protocol.
Certicate
Protocols - Select between HTTP & HTTPS and HTTPS only in
this drop down.
Password - Set the password for the uploaded PXF le.
Upload PFX File - Upload an already created PFX le. A folder
will pop up, select the le from the local computer and press
open.
Delete - If the current PFX le is no longer desired, press the
Delete button to remove it from the system.
YouTube Live
Enable slider - Select the slider to enable or disable the ability
to stream live through YouTube. When disabled, the option will
not appear on the Instructor page. It is recommended to keep
this option disabled if YouTube Live is not going to be used.
Key - The key will come from YouTube and takes a day to
activate. It is best to set up the YouTube live account before
proceeding with this step.
URL - Provide the URL associated with the YouTube live
stream.
Save - Once all the information is entered, select this button to
make the changes live on the WAVE.
NOTE: It is recommended to disable this feature when
using auto-queuing.