Owner's Manual

AT-WAVE-101
26
webGUI
IP Commands
IP Address and Port - Type in the IP address and port
of the display for commands to be sent to.
Time Display Control
Enable this section to have the Power On/O
command automatically sent to the display at a
certain time of day on dierent days of the week.
Start/End Time - Select the eld for a clock pop up to
appear. This will allow the start or stop time to be set
easily.
Days - Select the sliders next to the days of the week
to have the automatic on/o command to be sent.
The slider will be orange when enabled and grey when
disabled.
NOTE: If content is actively being displayed
during the o time, the WAVE-101 will delay the
power o sequence until all content has been
disconnected from the system.