Datasheet

Two-Input Wall Plate Switcher for HDMI and
VGA with Ethernet-Enabled HDBaseT Output
AT-HDVS-200-TX-WP
atlona.com
70 Daggett Road, San Jose, CA 95134
US Toll-free: +1.408.962.0515, International: +41.43.508.4321
©Atlona 2003-2016
The AT-HDVS-200-TX-WP is a 2×1 wall plate switcher for HDMI and VGA inputs with HDBaseT output. It features a
US, two-gang, Decora form factor with one HDMI and one VGA input with an always-on 3.5mm audio connector.
HDMI signals up to 4K/UHD @ 60Hz (YUV 4:2:0 color sub-sampling), VGA input signals up to 1920×1200, embedded
audio, and control signals can be extended up to 330 feet (100 meters). The switcher receives power from the AT-
HDVS-200-RX scaler via Power over Ethernet and together they create a standalone AV switching and control system
with scaling for classrooms and huddle rooms. Display control and volume commands are transmitted via CEC, IP, or
RS-232 to any display, control system, switcher or other controllable device.
The AT-HDVS-200-TX-WP can be the central component of a small, automated AV system. Automatic display control
turns-on the display automatically whenever a source is connected. When the source is removed, the display is turned
off. Volume is controlled by using the front panel or other control signals. Automatic input selection on the AT-
HDVS-200-TX-WP works by sensing the presence of any video signal. With automatic input selection, manual control
systems can be eliminated.
Using the AT-PS-POE, it can connect directly to Atlona HDBaseT receivers such as the AT-UHD-EX-100CE-RX or
projectors with HDBaseT inputs, enabling simplified control and adding legacy VGA inputs at the HDVS.
2×1 HDBaseT™ switcher -
• Features one HDMI input plus a VGA input with
3.5mm audio connector
• Allows advanced HDMI display devices to be used
with legacy VGA sources
Front panel Input Select, Display On/Off, and
Volume Control buttons -
• Offers convenient user features to override auto-
switching when two active sources are present plus
display and volume control
• Simple manual controls allow presenter to maintain
control of AV system
Automatic input selection using video signal
detection technology -
• Selects active input when sources are connected
• Eliminates need for complex control system in
AV systems
Automatic display control -
• Automatically changes projector power state based
on active or standby mode of switcher. Control
signals to display are transmitted via CEC. IP, RS-232
• Eliminates need for a complex control system in
small AV systems. CEC enables control of low-cost
consumer displays
TCP/IP and RS-232 control of switcher -
• Flexible control options for compatibility with third-
party control systems. RS-232 controlled from
HDBaseT connection
• Reduces integration time and costs
Ethernet-enabled, HDBaseT extension -
• One Ethernet connection connects both TS and RX
for control and management. Transmits IP and
HDMI up to 330 ft. (100m)
• Uses easy-to-integrate category cable for low-cost,
reliable system installation. Enables control of
switchers (CLSO-824)