Manual
AT-HDVS-200-TX-WP / AT-HDVS-200-TX-WP-BLK
37
Commands
Command Description
AnaGain Sets the gain of the analog audio input
APwrOTime Sets the power-o time interval
Aspect Sets the aspect ratio of the output signal
ASwFstTime Sets detect delay time when power on
ASwOutTime Sets the time interval for auto-switching when no signal is detected
ASwPrePort Sets which port to switch to when no signal is detected
AudioSrc Set audio source for the HDMI inputs
AutoDispO Enables or disables display auto-o
AutoDispOn Enables or disables display auto-on
AutoPwrMode Set the display mode for auto power on and o
AutoSW Enable or disables auto switching or display auto switching status
BASS Increases or decreases the amount of bass on the output
Blink Enables or disables blinking of the DN button on the front panel
Broadcast Enables or disables broadcast mode
BRT Sets the picture brightness
CliIPAddr Sets the IP address of the Telnet client
CliMode Sets the login mode of the Telnet client
CliPass Sets the password for the Telnet client
CliPort Sets the listening port for the Telnet client
CliUser Sets the username for the Telnet client
CSpara Sets the baud rate, data bits, parity bit, and stop bits for the serial port
CtlType Sets the control type for communcation with the display device
CTRST Sets the picture contrast
DispBtn Simulates pressing the DISPLAY button on the front panel
DispCEC Sets the display command type to CEC
DispIP Sets the display command type to IP
IMPORTANT: Each command is terminated with a carriage-return (0x0d) and the feedback is
terminated with a carriage-return and line-feed (0x0a).
The following tables provide an alphabetical list of commands available on the AT-HDVS-200-TX-WP. All commands
are case-sensitive and must be entered as documented. If the command fails or is entered incorrectly, then the
feedback is “Command FAILED”.