User Manual

The manufacturer must maintain a copy of the ATSAMR21G18-MR210UA module documentation and
ensure the final product does not exceed the specified power ratings, antenna specifications, and/or
installation requirements as specified in the user manual. If any of these specifications are exceeded in
the final product, a submission must be made to a notified body for compliance testing to all required
standards.
The CE marking must be affixed to a visible location on the OEM product. The CE mark shall consist of
the initials "CE" taking the following form:
• If the CE marking is reduced or enlarged, the proportions must be respected.
• The CE marking must have a height of at least 5 mm except where this is not possible on account
of the nature of the apparatus.
• The CE marking must be affixed visibly, legibly, and indelibly.
More detailed information about CE marking requirements can be found at "DIRECTIVE 1999/5/EC OF
THE EUROPEAN PARLIAMENT AND OF THE COUNCIL" on 9 March 1999 at section 12.
For the operation in Europe, there is no power setting limit.
6.3. Industry Canada (IC) Compliance Statements
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts
de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire
de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
This equipment complies with radio frequency exposure limits set forth by Industry Canada for an
uncontrolled environment. This equipment should be installed and operated with minimum distance 20 cm
between the device and the user or bystanders.
Cet équipement est conforme aux limites d'exposition aux radiofréquences définies par Industrie Canada
pour un environnement non contrôlé. Cet équipement doit être installé et utilisé avec un minimum de 20
cm de distance entre le dispositif et l'utilisateur ou des tiers.
CAUTION: Any changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment. The OEM integrator is still responsible for testing
their end-product for any additional compliance requirements required with this module installed (for
example, digital device emissions, PC peripheral requirements, etc.). This Module is labeled with its own
IC ID. If the IC ID Certification Number is not visible while installed inside another device, then the device
should display the label on it referring the enclosed module. In that case, the final end product must be
labelled in a visible area with the following:
“Contains Transmitter Module IC: 20266-ATSAMR210UA0”
OR
“Contains IC: 20266-ATSAMR210UA0”
Ce module est étiqueté avec son propre ID IC. Si le numéro de certification IC ID n'est pas visible lorsqu'il
est installé à l'intérieur d'un autre appareil, l'appareil doit afficher l'étiquette sur le module de référence ci-
joint. Dans ce cas, le produit final doit être étiqueté dans un endroit visible par le texte suivant:
“Contains Transmitter Module IC: 20266-ATSAMR210UA0”
Atmel ATSAMR21G18-MR210UA [DATASHEET]
Atmel-42475B-ATSAMR21G18-MR210UA_Datasheet_Preliminary-09/2015
15