User Manual

ATSAMR21B18-MZ210PA [PRELIMINARY DATASHEET]
Atmel-42486C-ATSAMR21B18-MZ210PA_Datasheet_03/2016
1
4
14
7 Radio Certification
The module ATSAMR21B18-MZ210PA in combination with the integrated antenna has received regulatory
approvals for modular devices in the United States, Canada and European countries.
7.1 United States (FCC)
The module ATSAMR21G18-MR210UA complies with the requirements of FCC part 15. To fulfill FCC
Certification requirements, an OEM manufacturer must comply with the following regulations:
 The modular transmitter must be labeled with its own FCC ID number, and, if the FCC ID is not visible
when the module is installed inside another device, then the outside of the device into which the module
is installed must also display a label referring to the enclosed module.
 This exterior label can use wording such as the following. Any similar wording that expresses the same
meaning may be used.
Sample Label for integration of ATSAMR21B18-MZ210PA:
Contains FCC-ID: VNR-ATSAMZ210PA-0
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This equipment complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation (FCC 15.19).
Installers must be provided with antenna installation instructions and transmitter operating conditions for
satisfying RF exposure compliance.
Modifications not expressly approved by this company could void the user's authority to operate this equipment
(FCC section 15.21).
7.2 Europe (ETSI)
The module ATSAMR21B18-MZ210PA is conform for use in European Union countries. If the
ATSAMR21B18-MZ210PA module is incorporated into a product, the manufacturer must ensure the compliance
of the final product to the European harmonized EMC and low-voltage/safety standards. A Declaration of
Conformity must be issued for each of these standards and kept on file as described in Annex II of the R&TTE
Directive.
The manufacturer must maintain a copy of the ATSAMR21B18-MZ210PA module documentation and ensure the
final product does not exceed the specified power ratings, antenna specifications, and/or installation
requirements as specified in the user manual. If any of these specifications are exceeded in the final product, a
submission must be made to a notified body for compliance testing to all required standards.
The CE marking must be affixed to a visible location at the OEM product. The CE mark shall consist of the initials
"CE" taking the following form:
 If the CE marking is reduced or enlarged, the proportions must be respected.
 The CE marking must have a height of at least 5 mm except where this is not possible on account of the
nature of the apparatus.
 The CE marking must be affixed visibly, legibly, and indelibly.