User's Manual

AVR600

8293-AVR-02/10

Figure 7-1 COM Port Settings

7.4 Install Software and Test

This step is only required for doing application development on the RZ600 kit.

1. Install GNU Toolschain – see section 2.

2. Install AVR32 Studio – see section 2.

7.5 Programming the Example Application

This step is only required for doing application development on the RZ600 kit.

1. Connect either a JTAGICE mkII or AVRONE! to your computer.

2. Go through the driver installation. Let the PC select the best USB driver for the

attached debugger. The AVR USB program takes care of this in the background.

3. Solder the 50 mil 10-pin connector to one of the processor board.

4. Mount a 100mil to 50mil adapter to the debugger and connect the probe to the

freshly soldered connector.

5. Use AVR32 Studio or IAR Embedded Workbench

to develop and debug

programs.