User's Manual

ZigBit™ 2.4 GHz Wireless Modules 4-22
8226C–MCU Wireless–09/10
Section 4
Agency Certifications
4.1 UNITED STATES (FCC)
This equipment complies with Part 15 of the FCC rules and regulations.
To fulfill FCC Certification requirements, an OEM manufacturer must comply with the following
regulations:
1. The modular transmitter must be labelled with its own FCC ID number, and, if the FCC ID is not visi-
ble when the module is installed inside another device, then the outside of the device into which the
module is installed must also display a label referring to the enclosed module. This exterior label can
use wording such as the following:
Example of label required for OEM product containing ATZB-24-A2 module
Example of label required for OEM product containing ATZB-24-B0 module
Any similar wording that expresses the same meaning may be used.
2. To be used with the ATZB-24-B0 module, the external antennas have been tested and approved
which are specified in here below. The ATZB-24-B0 Module may be integrated with other custom
design antennas which OEM installer must authorize following the FCC 15.21 requirements.
WARNING: The Original Equipment Manufacturer (OEM) must ensure that the OEM modular transmitter
must be labeled with its own FCC ID number. This includes a clearly visible label on the outside of the
final product enclosure that displays the contents shown below. If the FCC ID is not visible when the
equipment is installed inside another device, then the outside of the device into which the equipment is
installed must also display a label referring to the enclosed equipment.
IMPORTANT: This equipment complies with Part 15 of the FCC Rules. Operation is subject to the follow-
ing two conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation (FCC 15.19).
The internal / external antenna(s) used for this mobile transmitter must provide a separation distance of
at least 20 cm from all persons and must not be co-located or operating in conjunction with any other
antenna or transmitter.
Contains FCC ID: VW4A090664
The enclosed device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(i.) this device may not cause harmful interference and (ii.) this device must accept any interference received,
including interference that may cause undesired operation.
Contains FCC ID: VW4A090665
The enclosed device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(i.) this device may not cause harmful interference and (ii.) this device must accept any interference received,
including interference that may cause undesired operation.