User's Manual

Agency Certifications
ZigBit™ 2.4 GHz Wireless Modules 4-23
8226C–MCU Wireless–09/10
Installers must be provided with antenna installation instructions and transmitter operating conditions for
satisfying RF exposure compliance. This device is approved as a mobile device with respect to RF expo-
sure compliance, and may only be marketed to OEM installers. Use in portable exposure conditions
(FCC 2.1093) requires separate equipment authorization.
IMPORTANT: Modifications not expressly approved by this company could void the user's authority to
operate this equipment (FCC section 15.21).
IMPORTANT: This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protec-
tion against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications. Oper-
ation of this equipment in a residential area is likely to cause harmful interference in which case the user
will be required to correct the interference at his own expense (FCC section 15.105).
4.2 EUROPEAN UNION (ETSI)
The ATZB-24-A2 and ATZB-24-B0 Modules has been certified for use in European Union countries.
If the ATZB-24-A2 and ATZB-24-B0 Modules are incorporated into a product, the manufacturer must
ensure compliance of the final product to the European harmonized EMC and low-voltage/safety stan-
dards. A Declaration of Conformity must be issued for each of these standards and kept on file as
described in Annex II of the R&TTE Directive.
Furthermore, the manufacturer must maintain a copy of the ATZB-24-A2 and ATZB-24-B0 Modules doc-
umentation and ensure the final product does not exceed the specified power ratings, antenna
specifications, and/or installation requirements as specified in the user manual. If any of these specifica-
tions are exceeded in the final product, a submission must be made to a notified body for compliance
testing to all required standards.
IMPORTANT: The 'CE' marking must be affixed to a visible location on the OEM product. The CE mark
shall consist of the initials "CE" taking the following form:
 If the CE marking is reduced or enlarged, the proportions given in the above graduated drawing must
be respected.
 The CE marking must have a height of at least 5mm except where this is not possible on account of
the nature of the apparatus.
 The CE marking must be affixed visibly, legibly, and indelibly.
More detailed information about CE marking requirements you can find at "DIRECTIVE 1999/5/EC OF
THE EUROPEAN PARLIAMENT AND OF THE COUNCIL" on 9 March 1999 at section 12.
Certification Approved Antennas list is presented in below.