User Manual

ZigBit™ 2.4 GHz Amplified Wireless Modules 4-16
8228B–MCU Wireless–06/09
Section 4
Ordering Information
4.1 Ordering Information
Note: Tape&Reel quantity: 200
Part Number Description
ATZB-A24-UFLR
2.4 GHz IEEE802.15.4/ZigBee Power Amplified OEM Module with U.FL Antenna
Connector
ATZB-A24-U0R 2.4 GHz IEEE802.15.4/ZigBee Power Amplified OEM Module with Unbalanced RF output
Section 5
Agency Certifications
This equipment complies with Part 15 of the FCC rules and regulations. To fulfill FCC Certification requirements, an OEM
manufacturer must comply with the following regulations:
1. The ATZBA24UFL modular transmitter must be labelled with its own FCC ID number, and, if the FCC ID is not visible when the
module is installed inside another device, then the outside of the device into which the module is installed must also display a label
referring to the enclosed module. This exterior label can use wording such as the following:
Contains FCC ID: VW4A090668
The enclosed device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (i.) this device may
not cause harmful interference and (ii.) this device must accept any interference received, including interference that may cause
undesired operation.
Any similar wording that expresses the same meaning may be used.
2. Designs using the ATZBA24U0 module must be labelled on an external visible area with the following information:
Contains FCC ID: VW4A090667
The enclosed device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (i.) this device may
not cause harmful interference and (ii.) this device must accept any interference received, including interference that may cause
undesired operation.
WARNING: The Original Equipment Manufacturer (OEM) must ensure that the OEM modular transmitter must be labeled with its own
FCC ID number. This includes a clearly visible label on the outside of the final product enclosure that displays the contents shown below.
If the FCC ID is not visible when the equipment is installed inside another device, then the outside of the device into which the equipment
is installed must also display a label referring to the enclosed equipment.
IMPORTANT: This equipment complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation (FCC 15.19).
The internal / external antenna(s) used for this mobile transmitter must provide a separation distance of at least 20 cm from all persons
and must not be colocated or operating in conjunction with any other antenna or transmitter.
Installers must be provided with antenna installation instructions and transmitter operating conditions for satisfying RF exposure compliance. This device is
approved as a mobile device with respect to RF exposure compliance, and may only be marketed to OEM installers. Use in portable exposure conditions
(FCC 2.1093) requires separate equipment authorization.
IMPORTANT: Modifications not expressly approved by this company could void the user's authority to operate this equipment (FCC section 15.21).
IMPORTANT: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may
cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which
case the user will be required to correct the interference at his own expense (FCC section 15.105).