Datasheet

308
8011O–AVR–07/10
ATmega164P/324P/644P
24.8 Serial Downloading
Both the Flash and EEPROM memory arrays can be programmed using a serial programming
bus while RESET
is pulled to GND. The serial programming interface consists of pins SCK,
MOSI (input) and MISO (output). After RESET
is set low, the Programming Enable instruction
needs to be executed first before program/erase operations can be executed. NOTE, in Table
24-15 on page 308, the pin mapping for serial programming is listed. Not all packages use the
SPI pins dedicated for the internal Serial Peripheral Interface - SPI.
24.8.1 Serial Programming Pin Mapping
Figure 24-10. Serial Programming and Verify
(1)
Notes: 1. If the device is clocked by the internal Oscillator, it is no need to connect a clock source to the
XTAL1 pin.
2. V
CC
- 0.3V < AVCC < V
CC
+ 0.3V, however, AVCC should always be within 1.8V - 5.5V
When programming the EEPROM, an auto-erase cycle is built into the self-timed programming
operation (in the Serial mode ONLY) and there is no need to first execute the Chip Erase
instruction. The Chip Erase operation turns the content of every memory location in both the
Program and EEPROM arrays into 0xFF.
Depending on CKSEL Fuses, a valid clock must be present. The minimum low and high periods
for the serial clock (SCK) input are defined as follows:
Low: > 2 CPU clock cycles for f
ck
< 12 MHz, 3 CPU clock cycles for f
ck
>= 12 MHz
High: > 2 CPU clock cycles for f
ck
< 12 MHz, 3 CPU clock cycles for f
ck
>= 12 MHz
Table 24-15. Pin Mapping Serial Programming
Symbol
Pins
(PDIP-40)
Pins
(TQFP-44) I/O Description
MOSI PB5 PB5 I Serial Data in
MISO PB6 PB6 O Serial Data out
SCK PB7 PB7 I Serial Clock
VCC
GND
XTAL1
SCK
MISO
MOSI
RESET
+1.8V - 5.5V
AVCC
+1.8V - 5.5V
(2)