User manual

Monitor Tab

In the monitor tab, you can adjust the operating mode, infrastructure or ad-hoc,

which channel that can be used, which host/AP (SSID) you want to connect to, the

transmission rate (Tx Rate) and power management mode. Each of the setting is

described below:

 Operating mode selection

 Channel selection

 SSID selection

 Setting the Transmission rate

 Selecting power management

• MAC address

specifies the physical hardware address of your ATMEL USB

Wireless LAN.

• Status

specifies the current status. Status can be either Scanning,

Associated, Association denied and Ready

 Scanning – means you are not connected to any hosts/APs but your

WLAN is searching for a host/AP to connect to.

 Associated – means that you are connected to an Access Point. The

ID of the AP that you are connected to is given by the BSSID.

 Association denied – means that you are denied connection to the AP

that you want to connect to. Reason might be you have your

encryption enabled while the AP didn’t enable theirs, or vice versa.