Data Sheet

ATM2202
PRELIMINARY


7 July,27,2020


LABEL OF THE END PRODUCT:
The final end product must be labeled in a visible area with the following " Contains TX FCC ID:
2AXI2-ATM2-MOD-A-00 ".
This device complies with Part 15 of FCC rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference and (2) this device must accept any interference
received, including interference that may cause undesired operation.

Ant. Brand ModelName AntennaType Gain(dBi)
1
Atmosic BT001
Printed 4.42


This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and
Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two
conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired
operation of the device.
Cetappareilcontientdesémetteurs/récepteursexemptsdelicencequisontconformesau(x)RSS(s)exemptésde
licenced'Innovation,SciencesetDéveloppementéconomiqueCanada.L'opérationestsoumiseauxdeuxconditions
suivantes:
(1)Cetappareilnedoitpasprovoquerd'interférences.
(2)Cetappareildoitacceptertouteinterférence,ycomprislesinte
rférencessusceptiblesdeprovoquerun
fonctionnementindésirabledel'appareil.

IMPORTANT NOTE:
This module is intended for OEM integrator. The OEM integrator is responsible for the
compliance to all the rules that apply to the product into which this certified RF module is
integrated.
Additional testing and certification may be necessary when multiple modules are used.
20cm minimum distance has to be able to be maintained between the antenna and the users for the
host this module is integrated into. Under such configuration, the IC RSS-102 radiation exposure
limits set forth for an population/uncontrolled environment can be satisfied.
Any changes or modifications not expressly approved by the manufacturer could void the user's
authority to operate this equipment.
USERS MANUAL OF THE END PRODUCT:
In the users manual of the end product, the end user has to be informed to keep at least 20cm
separation with the antenna while this end product is installed and operated. The end user has to be
informed that the IC radio-frequency exposure guidelines for an uncontrolled environment can be
satisfied.
The end user has to also be informed that any changes or modifications not expressly approved by
the manufacturer could void the user's authority to operate this equipment. Operation is subject to