User's Manual

64 65
5. Select Local as the card issuing mode.
Figure 7-2. Issue a Card by Local Mode
6. Set other related parameters.
Card Enrollment Station
Select the model of the connected card enrollment station.
NOTE
Currently, the supported card enrollment station models include
DS-K1F100-D8, DS-K1F100-M, DS-K1F100-D8E, and DS-K1F180-D8E.
Card Type
This field is only available when the model is DS-K1F100-D8E or DS-
K1F180-D8E. Select the card type as EM card or Mifare card according to the
actual card type.
Buzzing
Enable or disable the buzzing when the card number is read successfully.
Card No. Type
Select the type of the card number according to actual needs.
M1 Card Encryption
This field is only available when the model is DS-K1F100-D8, DS-K1F100-
D8E, or DS-K1F180-D8E. If the card is M1 card, then you can enable the M1
Card Encryption function and select the sector of the card to encrypt.
7. Click OK to confirm the operation.
8. Place the card on the card enrollment station and click Read to get the
card number. The card number will display in the Card No. field automat-
ically.
9. Click Add.
The card will be issued to the person.
7.4.4. Upload a Face Photo from Local PC
When adding person, you can upload a face photo stored in local PC to the
client as the person's profile.
Steps
1. Enter Person module.
2. Select an organization in the organization list to add the person and click
Add.
NOTE
Enter the person's basic information first. For details about configuring
person's basic information, refer to Configure Basic Information.
3. Click Add Face in the Basic Information panel.
4. Select Upload.
5. Select a picture from the PC running the client.
NOTE
The picture should be in JPG or JPEG format and smaller than 200 KB.
6. Optional: Enable Verify by Device to check whether the facial recognition
device managed in the client can recognize the face in the photo.
7. Confirm to add the person.
• Click Add to add the person and close the Add Person window.
• Click Add and New to add the person and continue to add other persons.
7.4.5. Take a Photo via Client
When adding a person, you can take a photo of the her/him via the client and
set this photo as the person's profile.
Before You Start
Make sure PC running the client has a camera or you have connected other
USB camera to the PC.
Steps
1. Enter Person module.
2. Select an organization in the organization list to add the person and click
Add to enter Add Person window.
NOTE
Enter the person's basic information first. For details, refer to Config-
ure Basic Information.
3. Click Add Face in the Basic Information area.
4. Select Take Photo to enter Take Photo window.
5. Optional: Enable Verify by Device to check whether the captured face
photo can meet the uploading requirements.
6. Take a photo.
a) Face to the camera and make sure your face is in the middle of the col-
lecting window.
b) Click
to capture a face photo.
c) Optional: Click
to capture again.
d) Click OK to save the captured photo.