User's Manual

12 13
Table 2-1. Description of Face Recognition Terminal
No. Name
1 USB Interface
2 Card Swiping Area
3 Touch Screen
4 Camera
5 IR Light
6 White Light
7 Thermographic Module
8 IR Light
9 Camera
10 TAMPER
11 Thermographic Module Interface
12 Debugging Port
13 Power Interface
14 Wiring Terminals
15 PSAM Card Slot (Reserved)
16 Network Interface
CHAPTER 3. INSTALLATION
3.1. INSTALLATION ENVIRONMENT
• Avoid backlight, direct sunlight, and indirect sunlight.
• For better recognition, there should be light source in or near the installa-
tion environment.
• Indoor and windless environment use only.
NOTE
For details about installation environment, see Tips for Installation
Environment.
3.2. FLUSH MOUNTING
Steps
1. Install a gang box.
2. Connect the thermographic module and the main body.
Figure 3-1. Connect Thermographic Module
3. Use 5 supplied screws (4_KA4×22-SUS) to secure the mounting plate on
the gang box.
4. Route the cable through the cable hole of the mounting plate and connect
to corresponding external devices’ cables.
5. Align the device with the mounting plate and hang the device on the
mounting plate. Make sure the two sheets on each side of the mounting
plate have been in the slots at the back of the device.
Figure 3-2. Install Device