Specifications

Operation Manual
Lysar Industries
Page 9
5. INSTALLATION
5.1. Installation EQ-Link system
The EQ-Link system is supplied with a standard aviation cables and
connectors (jacks) to suit standard aviation connections. The EQ-Link system
will automatically power ON when the aircraft communications system is
turned on, and will automatically power off when the communications is
switched off. A permanent optional charge cable can be connected for peace
of mind to ensure the EQ equipment is always charged.
When your aircraft communications is switched off the EQ-Link and EQ
Reverse-Link will automatically power OFF after about one minute. Simply
connect your EQ-Link into where your normal headset would be connected.
The EQ-Link is supplied with Velcro for simple mounting and a cable clip for
additional support. For additional performance operation when multiple EQ-
Link units are used on one aircraft simply set extra units to SLAVE mode. In
this mode all the units will operate as one and not interfere with each other,
there must be at lease one EQ-Link in master mode in all systems.
Slave mode can be entered by pressing and holding the STATUS button for 4
seconds, the LED lights will then change every 2 seconds from Master to
Slave and announce this in the headset. When on the desired mode, just
release the button.
Plug your normal headset into the connections on the EQ R-Link, press and
hold the ON button for 4 seconds and the EQ R-Link will turn ON.
NOTE: A typical aircraft can only have one master and up to 5 slaves in the
single system for peak performance, in the case of more units please contact
your supplier for additional information on your options.
YOUR INSTALLATION IS NOW COMPLETE…………