- TOSHIBA Internal Modem User's Guide V.9256K

Using the Internal Modem

Basic operation

5.375 x 8.375 ver 2.4.0

CTS/RTS control

This control method is hardware-dependent. To control data

flow, the modem and computer transmit Clear To Send/

Request To Send signals to each other. To set CTS/RTS

control, enter the following AT command:

AT\Q3

XON/XOFF control

This control method is managed by software. The start/stop

signals, that is transfer on/transfer off, are included in the data

stream. To set XON/XOFF control, enter the following AT

command:

AT\Q1

Please use any settings recommended in your

communications software manual.

Facsimiles

Fax communication uses EIA-578 Class 1 commands and

requires fax software. Communication is controlled by the

fax software.

NOTE: Use only software compatible with EIA-578 Class 1. Do not

use EIA-592 Class 2-compatible software.