Owners Manual

ATOLL ELECTRONIQUE
IN200 Sig
ATOLL ELECTRONIQUE
OWNER’S MANUAL ~ INTEGRATED
Page 3Page 6
BLUETOOTH®
Your appliance allows the reception of audio signals sent since any device having
a Bluetooth® transmitter (Smartphone, tab, computer…).
First time association:
• Activate Bluetooth connectivity on your sending device.
BT
is
displayed.
• Select it from the list of devices (named IN200).
• Once the connection is made, the symbol
BT
appears.
All the audio signals that will be played on your source device will then be
transmitted to your device. The device remains paired until the IN200 is turned off
or the connection is terminated. It will remain visible to your transmitter.
Association of another emitter: Once associated with any transmitter, it is essential
to completely turn off your device at the ON/OFF switch to be able to make it
visible to another transmitter.
For better reception quality, avoid being more than 5 meters from your device.
Your device is equipped with an asynchronous USB (type B) input (16). You will only
be able to use it after installing the correct driver on your computer. This driver can
be downloaded freely from our website:
• Accepted format on optical and coaxial Inputs: 16-24 bits (32 kHz, 44,1 kHz,
48 kHz, 88,2 kHz, 96 kHz, 176,4 kHz and 192 kHz).
• Accepted format on USB Input:
– DSD: DSD64 & DSD128.
– PCM: 16-24 bits (32 kHz, 44,1 kHz, 48 kHz, 88,2 kHz, 96 kHz,
176,4 kHz, 192 kHz, 352,8 kHz et 384 kHz).
You will find attached an explanatory note on its installation.
This driver is not required for Macintosh computers.
In order to avoid problems with high quality format transfers
(24 bits / 192kHz), it is recommended to use a USB
connection cable with ferrite.
USB INPUT (16)
ACCEPTED FORMATS
CAUTIONS
• Do not make any connections when your device is powered on.
• Put your device in a dry and well ventilated place, far from source
of heat.
• Make sure you never put anything on your amplifier.
• Avoid any short-cut.
• Strictly respect polarity
+
& , as well as the left and right
connections.
• Do not plug-in two speakers in parallel on the same output.
ADVISES
• To optimize the performance of your device, you should switch
it on at least half an hour before any listening, the time for the
power stage to reach its ideal working temperature.
• Your device will give you optimal listening quality after this time-
lapse.
• Between two uses, it is, therefore, preferable to let the device
in the standby position so that it remains at its optimum
temperature.
• At night or when you leave your home, it is best to use the main
switch to turn off the device.
• To optimize the sound quality of your system, we recommend that
you choose good-quality connection cords. Do not hesitate to
ask your specialist dealer for advice.
http://www.atoll-electronique.com/fr/produits/convertisseur-dac/convertisseur-dac200/