Owner's Manual
OWNER’S MANUAL ~ STREAMER
ATOLL ELECTRONIQUE
Page 6
4 - CONNECTING SETUP
SOURCE MODE OR PREAMPLIFIER (BY-PASS)
TRIGGER LINK
MS120
Source
Integrated like IN200
Streamer MS120
Power amplier
RQ.: You can switch on every line IN of the integrated.
Preamp
Power amplier
This device can be used as a source (like a CD player) or as a preamplifier which gives the ability to control
the volume.
The diagrams below show the wiring possibilities according to these different applications.
This appliance is equipped with a Trigger that allows the switch ON/OFF of any amplifier equipped with the
same kind of trigger inputs (amplifier ATOLL AM200SE).
Appliances must be linked as shown below:
Therefore, at each standby output Streamer, the amplifier will turn on. It will also turn off each time it goes to sleep.
So that the system is operating, the ON/OFF button of your AM200SE must remain in position OFF (0). If the
switch is in the ON position (1), the amplier will work but not the Trigger function.
Using the Streamer as a source
directly linked to an integrated or a
preamplifier. BY-PASS mode should
be active and the BY-PASS led (a)
switch on.
Using the Streamer as a preamplifier
directly connected to a power amplifier (or
active speakers). BY-PASS mode should be
not active and the BY-PASS led (a) switch
off.
Trigger cable must be a stereo Male to Male jack plug 3,5 mm (1/8”).
Headphones Jack
Ø 3,5 mm