Owner`s manual

20 21
Store the regulator out of the sun to prevent fading and deterioration of the rubber and
plastic parts, away from excessive heat, humidity or insects.
The SS1 can be easily removed from the BCD for storage with your primary regulator by
unscrewing the adapter and separating it from the BCD hose.
Required Maintenance
The major service interval for the SS1 is semi-annual (2 years). We recommend that you
take your SS1 to an authorized Atomic Aquatics dealer annually for a safety inspection. At
this time, they will inspect and check for proper operation, and advise if a major service is
required. The major service will include replacement of all seals, seats and o-rings. The
labor charges for this service will vary with the individual dealer. Parts replacement will be
in accordance to the terms of the limited lifetime warranty in this manual. Factory service
is also available.
CAUTION
Do not attempt any disassembly or repair of the SS1. Disassembly and
service of the SS1 must only be performed by an authorized, factory trained
scuba repair technician or by the factory.
SPECIFICATIONS: SS1
Description: Combination inflator and high performance downstream second stage regulator.
Materials: (SS1 Stainless) (SS1 Titanium)
Inflation/Deflation stems 316 Stainless Titanium
Quick disconnect 316 Stainless/Brass Titanium/316Stainless/Brass
Demand valve body 316 Stainless/Brass Titanium
Orifice 316 Stainless 316 Stainless
Lever Titanium Titanium
Springs Stainless Stainless
Diaphragm Silicone rubber Silicone Rubber
Mouthpiece Silicone rubber Silicone rubber
Body Fiberglass Reinforced Nylon Fiberglass Reinforced Nylon
Weights and dimensions:
SS1 w/o hose 200g (7 oz.) 180g (6.3 oz)
LP hose/w disconnect 200g (7oz.) 190g (6.7 oz.)
LP hose length (all) 71 cm (28")
Pressure rating (all) 8.6-10 bar (125-145 psi)
MAINTENANCE / SPECIFICATIONS
SS1 owner's manual 7-05 7/26/05 5:21 PM Page 21