Instruction Manual

Figure 1
©
2012 Escalade Sports
For Customer Service Call 1-888-996-2729
5
All Rights Reserved.
STEP 1:
On a clean level surface, place each Side Rail Apron P1, each End Rail Apron P2, and each Corner Post
P10 upside down as shown in Figure 1. Next, attach each Corner Post using Phillips Round Screws H3.
PARTS REQUIRED:
16 pcs - H3 Phillips Round 2 pcs - P2 End Rail Apron
Head Screw 4 pcs - P10 Corner Post
2 pcs - P1 Side Rail Apron
STEP 2:
With the help of another adult, place Playfield P3 face down into the cabinet assembly and attach using
Phillips Washer Head Screws H1 as shown in Figure 2.
P1
P2
P10
P10
P2
P10
P10
H3
H3
P1
NOTE: Make sure Corner Post
is in this position for
correct assembly.
NOTE: These assemblies are
being built upside down.
PARTS REQUIRED:
22 pcs - H1 Phillips Washer Head Screw
1 pc - P3 Playfield
H1
P3
Figure 2
IMPORTANT NOTE: Playfield must be lowered into cabinet evenly on both ends at same time. Cabinet must be assembled
in a perfect rectangle. If playfield is still difficult to lower into cabinet , remove the top H3 corner post screws, carefully install
playfield, and reinstall H3 corner posts screws. Be careful to not strip these screws out.