Operation Manual

VirtualDJ 8 - User’s Guide
101
When Timecode is part of the applied Audio Setup, additional Timecode panels will be
available in the GUI of VirtualDJ showing the strength of the signal along with buttons to turn
on/off the timecode control
Timecode panels in Decks - 2 Decks GUI
Timecode panels in the SCRATCH panel - 4 Decks
GUI
Note. In order to use VirtualDJ’s timecode capabilities, the sound card must be able to provide a
stereo signal on the appropriate input channels. Mono input of a timecode signal is not supported.
Additional Setup for Recording
Using an Audio Setup with Master Output (Speakers), the recording is performed internally,
so no special connection or Audio Setup is required.
In case of an external mixer setup though, the recording cannot be performed internally, as
the external mixer is not capable to control the internal mixer of the software. In this case an
additional connection and a Record line in Audio Setup are required
Connections
Recording with a 2 Channel External Mixer & USB multi-channel sound card - Connections
VirtualDJ Audio Setup
Select the EXTERNAL MIXER and INTERNAL SOUND CARD options. Once the Audio
Setup is created select your USB sound card from the SoundCard field. VirtualDJ will
then route each of the available decks to a separated stereo channel of your USB sound
card. Once the audio setup is created (with decks 1 to 2 or 4 (depending on the deck you are
about to use), create an additional line as below, by choosing Record from the Source list.
VirtualDJ will then record the specified Input.
Click APPLY.