Operation Manual

VirtualDJ 8 - User’s Guide

The CARD tab of Audio Settings

offers Internal Soundcard, Two

Soundcards and Stereo to Mono

Splitter options.

Choose INTERNAL SOUNDCARD

option if you need VirtualDJ to use

the default soundcard of your

computer

Choose TWO SOUNDCARDS option if you need to route Master and Headphones to

different sound cards (e.g. the built-in soundcard of your computer only offers a single stereo

output and need to use a USB one for pre-listening)

Choose STEREO TO MONO SPLITTER option in case you need to use the single stereo

output of your sound card for both Master and Headphones Output (requires a Y-Splitter

Stereo to 2 x Mono adaptor/cable)

The INPUT tab of Audio settings offers Microphone,

Timecode and Line Input options.

Choose MICROPHONE option if you wish to assign

an Input channel of a sound card as a microphone

input.

Choose TIMECODE SIGNAL option if you wish to

control VirtualDJ operations with timecoded vinyl’s or

CDs (see Timecode)

Choose LINE INPUT if you wish to assign an Input

channel of a sound card as an Line Input (AUX)

Additional buttons (options) may be provided in the CARD tab of Audio Settings, if a

natively supported MIDI/HID device with built-in audio interface is connected. Click on that

button and VirtualDJ will auto-create a pre-defined Audio Setup for that unit. In the picture

above, a Pioneer DDJ-WeGO is connected, and the button will create an Audio Setup with

Master to Chan 1&2 and Headphones to Chan 3&4 of the Pioneer Audio Interface.

Advanced Audio Settings

The middle section of the Audio Setup provides a detailed list of the current audio Setup.

Each time a choice is made using the top Output, Sound Card and Input tabs, lines are auto-

generated in this area using the default soundcard of your computer. Use the fields of these

lines to modify the Source (Master, Headphones, Decks, Line Inputs, and Microphone etc.),

the Sound card and its channels you wish to apply to each Source.