Quick Start Guide
Atomos Shogun Studio 2 - Quick Start Guide | 5
Physical features cont.
DC Input for Japanese
market version
6 67 781012 139 911
Rear of unit
The rear panel of Shogun Studio 2 has been laid out symmetrically to
align the connections with the recorder channel monitor when viewed
from the front.
6. SDI In/Out
BNC connectors for SDI inputs in HD/3G/6G/12G as indicated. Loop
supporting up to 12G 4kp60 and should be used to connect channel 1
to channel 2. SDI input 1 can also be used as a secondary output in
playback mode.
7. HDMI In/Out
HDMI input connection used to record to the Shogun Studio 2 supports
up to 4Kp60. HDMI output connection provides a live loop out or play out
when in Playback mode. Loop out between Channel 1 and Channel 2 is
limited to 4kp30.
8. Analogue Audio
Each recorder channel has 2x XLR inputs and 2x XLR outputs. The inputs
can be congured at Line, Mic and Pro level in the Audio menu. The inputs
can also provide 48V Phantom power to compatible microphones. The
XLR outputs are for monitoring and the audio channel routed to them can
be selected via the headphones selection in the Audio menu.
9. Synchronization
Each Recorder channel has Genlock input and output via BNC as well as
LTC Timecode input and loop output.
Please note that the output of the Genlock and LTC are only for
loop out and the Shogun Studio 2 cannot generate either Genlock or
LTC Timecode.
Operation of LTC can be found in the Timecode menu & operation of
Genlock found in the Output menu when in Playback mode.
10. RS422 9pin D-Sub
Each recorder has its own dedicated 9pin D-Sub for RS422 machine
control. Simply connect your RS422 cable from a qualied device or
controller to the relevant port on the Shogun Studio 2. A list of supported
devices and RS422 commands are dened in the user manual.
11. AC Power inputs
AC1 and AC2 inputs with IEC C14 sockets. Refer to Shogun Studio 2 User
Manual for more information.
Units purchased in Japan will have a different power input conguration, as
pictured below.
12. USB Port
For SERVICE ONLY and should only be used if instructed to do so as part
of rmware updates.
13. RJ45 connection
For SERVICE ONLY and should only be used if instructed to do so as part
of rmware updates.
CHANNEL 2 CHANNEL 1
DC Input for Japanese
market version