User's Manual

ABLEPick pick-to-light user manual
8
User needs to use the same RF tag to push the confirmation button again to confirm this
picking (double hits). Then the small button will be off to mean its picking is completed.
And the message on the prompt buffer will be shown up for 2 sec (such as
“End”…etc).automatically.
With the RF design, AT707-A-4K-RF allows system software to track each pick back to
a specific picker, by this way, each picker’s productivity could be countable accurately.
And its Multi-color LED identification increases operating flexibility and productivity by
allowing concurrent operating in one area.
AT707-A-4K-RF also uses different beep sound to distinguish different RF reading in
different states, such as error reading, no reading, or first data withdrawal and second data
confirmation.
Large illuminated confirmation button.
AT707-A-4K-RF’s confirmation button has 6 colors LED design, which are RED, GREEN,
AMBER, BLUE, PURPLE and INDIGO individually. The default color is RED. LED’s
color can be configured by software, which can be stored in the EEPROM.
Two up/down count buttons
The left side of AT707-A-4K-RF has two small illuminated buttons, up-count(function
key) with WHITE LED, and down-count (shortage) buttons with WHITE LED, too. Push
shortage (down-count) button can acknowledge the shortage situation or by adjusting
up-count/down-count button to present partial picking process. Both different behaviors
could be configured by software.
AT707-A-4K-RF’s power on procedure
Step1: The 7-segment will show “8“ from 1st digit to last digit sequentially(from right to
left).
Step2: 6 illuminated buttons include 2 arrows and 4 small buttons will flash once.