User Manual

User manual Version 1.0
ABLELink Wireless Serial Server
SW2001
Copyright © 2006 Atop Technologies, Inc.
All rights reserved. Designed in Taiwan.
46 / 51
A.4 LED Indication for Link Status
A.4.1 Detect SW2001 startup
“ ^ “ : Beep twice
“ = “ : Beep off
Message
Description
^==^========^^^
(5sec)
Startup OK and AP firmware is enabled
Table 1. Buzzer indication
A.4.2 Detect SW2001 Signal Strength
The BSS quality can be detected by LED indication in SW2001.
Run-time
When run-time, if the default key is pressed and then released, one of the specified actions will be down
depending on the released time after you heard how many beeps.
BSS quality is indicated by count of LEDs, which is shown as bellowed:
Blink RED There is no signal detected
One RED The quality is between is 0%~20%
2 LEDs The quality is between is 20%~40%
3 LEDs The quality is between is 40%~60%
4 LEDs The quality is between is 60%~80%
5 LEDs The quality is between is 80%~100%
LAN LED
Message
Description
LED Off
No data is transmitting on Ethernet
LED blinking
Data is transmitting on Ethernet
Table 2. LAN LED Message
COM Port LED