User Manual

User manual Version 1.0

ABLELink

Serial-Ethernet Server

SW5001

45 / 50

A.4 LED Indication for Link Status

A.4.1 Detect SW5001 startup

“ ^ “ : Beep twice

“ = “ : Beep off

Message

Description

^==^========^^^

(5sec)

Startup OK and AP firmware is enabled

Table 1. Buzzer indication

A.4.2 Detect SW5001 Signal Strength

The BSS quality can be detected by LED indication in SW5001.

Run-time

When run-time, if the default key is pressed and then released, one of the specified actions will be down

depending on the released time after you heard how many beeps.

BSS quality is indicated by count of LEDs, which is shown as bellowed:

Blink RED There is no signal detected

One RED The quality is between is 0%~20%

2 LEDs The quality is between is 20%~40%

3 LEDs The quality is between is 40%~60%

4 LEDs The quality is between is 60%~80%

5 LEDs The quality is between is 80%~100%

LAN LED

Message

Description

LED Off

No data is transmitting on Ethernet

LED blinking

Data is transmitting on Ethernet

Table 2. LAN LED Message

COM Port LED