Owner`s manual

22
139435_A GZ 455 DV 8/28/12
6.6 Firebox Liner Installation
Figure 6.12.
Remove side spacer panel for refractory panel installation.
MirroredReflectiveGlassPanels-157413
BlackReflectiveGlassPanels-157414
DesertSandRefractoryPanels-157407
6.6.1 Glass Firebox Panels
1. Unpack the glass panels and inspect. Notify your dealer
of any damage. Do not install damaged panels.
2. If it has not already been removed, lift the burner media
tray and skirt assembly out of the firebox.
3.ResttheRearpanelonthefireboxfloorwiththe
textured surface against the rear wall of the firebox.
4. OrienteachSidepanelwiththetexturedsideagainst
the wall panel spacers. A small retainer tab is located at
each side of the firebox ceiling near the front opening.
Bend each tab out enough to engage with the upper
edge of the glass panel. Fig. 6.11.
5 Bend the retainer tabs down to secure the glass panel
in place.
6.Replacetheburnerskirtassembly.
6.6.2 Refractory Panels:
1. Upack the panels and inspect notify your dealer of any
damage. Do not install damaged panels.
2. If it has not already been removed, lift the burner media
tray and skirt assembly out of the firebox
3.RemoveeachsteelSideSpacerPanelfromthefirebox.
You will need to bend the retainer tabs out slightly to
disengage the Spacer Panels. See fig. 6.12.
4. BeginningwiththeRearPanel,placeeachRefractory
Panel in position against the firebox walls and bend the
retainer tabs down to secure.
Figure 6.11. Panel Retainer Tab
REMOVE STEEL
SIDE SPACER
DO NOT
REMOVE STEEL
SIDE SPACER