Owner`s manual
24
139435_A GZ 455 DV 8/28/12
6.8 Surround Assembly
6.8.1 FacePlateBracketAdjustments
1. Usea1/4”socketdriverorflatscrewdrivertoloosen
thetwosheetmetalscrewsthatsecuretheCentering
Plate(Fig.6.15).PulltheCenteringPlateouttothe
depth appropriate to clear the finished wall surface.
2. LoosenthewingnutsonthetwosideAdjustment
Brackets and pull them out the same distance as the
CenteringPlate.
Figure 6.16.
Face Plate bracket adjustment.
Figure 6.17.
install hanger brackets on Front Face Plate
6.8.3 FrontFaceInstallation
1. Usea1/4”wrenchorsocketdrivertoinstallthetwo
Face Plate Hanger Brackets onto the back of the Face
Plate using the pre-installed nuts as shown in Fig. 6.17.
2. Hang the Face Plate on the Surround Support Brackets
inboard of the Backer Plate hangers.
Figure 6.15.
Access points to loosen the Centering Plate screws.
6.8.2OptionalBackerPlateInstallation
1. HangtheBackerPlateonthesideadjustmentbrackets,
engaging its center tab with the slot in the Support
Plate. See Fig. 6.16.
2. Push the Backer Plate back against the finished wall
face and tighten the nuts on the side brackets and
centering plate.
CenteringPlate
Access Ports