Owner`s manual
26
139435_A GZ 455 DV 8/28/12
6.10.1FlameAppearance/AirShutter
Adjustment
LocatethePrimaryAirShuttercontrolunderthe
firebox floor. The shutter is set at the at the factory for
Naturalgas.Thiswillgivegoodresultsinthemajority
of installation configurations, however, it may be
necessarytoadjustittogetthebestflamepicture
depending upon the specific venting configuration.
To change the setting, loosen the wing nut on the
shutter stem which is located under the firebox floor,
directlyabovetheAccentLampcontrolknob.Fig.6.21.
Adjustingthestemtotheleftwilldecreaseair.
Adjustmenttotherightwillincreaseair.
Generally, flame appearance is a matter of
individual preference, however a warm yellowish
flame is most common.
Closingtheairshutter-inextremecasesmay
generate very long yellow flames resulting in soot.
Sooting produces black deposits on the logs, on the
inside walls of the appliance, and potentially on the
exterior termination cap.
Sooting is caused by incomplete combustion in the
flames and lack of combustion air entering the air
shutter opening.
Opening the air shutter - will generate a flame that
isblueandtransparent,or“anemic”.Thisflameis
generally more efficient, but not as attractive.
Allow the burner to operate at the highest setting
for20-30minutesbeforemakinganyadjustments.
Alwaysmakeadjustmentsin1/8”incrementsand
allow the burner to settle-in for 10- 15 minutes
betweenadditionaladjustments.
6.11 Operation Notes
1. For the first several hours of operation, it is common
to detect some odor as the metal and manufacturing
materials cure under heat. This condition is temporary
and can be alleviated by allowing plenty of fresh air to
circulate through the area.
2. Condensationmaydevelopontheglassuponeach
lightingoftheappliance.This“fog”willdisappearas
the glass heats.
3. IMPORTANT:Itwillbenecessarytocleantheglass
afterthefirstfewfires.Awhitepowderyresiduewill
beevidentwhichresultsfromtheburnermediacuring.
Useanon-abrasivehouseholdglasscleanerandwarm
water.IFTHEGLASSISNOTCLEANED,THISRESIDUE
CANCAUSETHEGLASSTOBECOMEPERMANENTLY
ETCHED.DONOTUSEAMMONIA-BASEDCLEANERS.
4. Keepthecontrolcompartmentsandareaunderthe
appliance free of dust. Always keep the appliance area
clear and free from combustible materials, gasoline
and other flammable liquids.
5. This appliance can be operated with a continuously
burning pilot flame. Exercise caution when using
household products containing combustible vapors.
6. CAUTION: DO NOT OPERATE THIS APPLIANCE
WITHTHEGLASSREMOVED,CRACKEDORBROKEN.
REPLACEMENTOFTHEGLASSSHOULDBEDONE
BYALICENSEDORQUALIFIEDSERVICEPERSON.
USEONLYREPLACEMENTGLASSPROVIDEDBY
YOUR AUTHORIZED ATRA DEALER. NEVER USE ANY
SUBSTITUTEMATERIALS.
WARNING:
AIRSHUTTERADJUSTMENTSSHOULDONLYBE
PERFORMEDBYAQUALIFIED,PROFESSIONAL
SERVICE TECHNICIAN.
Figure 6.21. Air Shutter adjustment.
CLOSED OPEN
Figure 6.22. Correct flame pattern for both StarFire Glass and Tumbled Stones.